how to hook up analog to digital converter box

Supplies: You will need your analog TV, the antenna you have been using (indoor or outdoor), the twin-lead wire that currently connects your antenna to your TV, and two adaptors or 'matching transformers' as shown below. Then you could use that to feed over to a 12 VDC converter box.This guide describes installation of a digital-to-analog-converter box if your TV set has twin-lead terminals for attaching the antenna, instead of a coaxial connector plug or port. It's a clusterfk of cables though.ĭoes this TV have a battery compartment? If so I would measure if 12 VDC is present on that wall-wart input with batteries installed. I use an Artec converter box since it runs off of 12 VDC, so I plug them into a cig lighter socket. I have a similar setup for my van/camping but it's a small LCD that I'm fortunate has composite and stereo inputs. Also nice to use one of the less power hungry converter boxes. Just have to buy or build a battery pack that matches the box's requirement. Nonetheless it can be done with any converter box that will accept an external DC source pretty much has to be a wall-wart model. I remember back in the day there was a converter box sold with an optional external battery pack. The only thing you can use that TV's monopole VHF antenna for is to hold a clip-on UHF loop antenna. Keep in mind you'll need an antenna for the converter box. a converter box) so you may have to locate the source several feet away to eliminate a noisy picture.

That ol' TV may not be immune to digital noise generated by modern electronics (i.e. Before you go too far try it out with whatever you have on hand (any source that has a ch 3/4 coax output although a converter box would be preferred). Hopefully it will tune to channel 3 or 4 OK with that mechanical tuner.

How to hook up analog to digital converter box